JESLED T8 T10 T12 8FT LED Light Bulbs, Single Pin Fa8 Base, 8 Foot LED Fluorescent Tube

Make It Yours – See Your Price On Amazon!

Your Sales Price $79.99 - $74.99

A quick rundown of this product’s key features:

Our Top Reviews

Reviewer: Roy
Rating: 5.0 out of 5 stars
Title: Very pleased
Review: The package of twelve 96″ single pin LED’s arrived quickly and undamaged. I was impressed with the packaging and pleased none of the LED’s were damaged during shipping. Installation required removal of the old ballasts and rewiring of the fixture, but was easy and relatively quick. I am pleased with the increased illumination the LED’s provide and have ordered another twelve LED package.

Reviewer: Motengator
Rating: 5.0 out of 5 stars
Title: I’m very pleased with these replacement lamps.
Review: My garage has never been brighter.

Reviewer: Amazon Customer
Rating: 5.0 out of 5 stars
Title: You wont regret these!
Review: We have installed around 150 of these lights in our facility with only 2 failures after a couple of years. Great value for the money versus big name brand. Also these are super bright and really brighten up the area around where installed!

Reviewer: Platinum Girl
Rating: 5.0 out of 5 stars
Title: Fantastic Product, bright, ease to install, durable
Review: These are terrific. Easy to install, just remove the ballast and toss it, wire the 115 volt line wire (Black) to the tombstones on one end of your fixture and the neutral (white) wire to the tombstone on the opposite end. The whole process takes about 15 minutes per ballast once you get a bit of practice. Each bulb is brighter than the florescent bulbs.They are amazingly resilient. The bulbs I replaced are at the ceiling of my aircraft hangar, thus located about 25 feet above the concrete floor. While installing them one of the bulbs fell off of the Genie Lift and landed hard on the concrete floor, then bounced a couple of feet. When I retrieved it there was no visible damage, not a crack nor a bend. So I took it right back up to the ceiling and installed it. Perfect light, it lit up without a hitch and has worked ever since.The bulbs are light weight with what appears to be a full length aluminum housing the entire length. The two strips of LED ribbon are attached and covered with a plastic cover. The quality appears to be exceptional, and the packaging they came in was phenomenal. I am not easily impressed. I have been a contractor for 40 years, and I work on Aircraft all the time. My trades demand quality…and I am impressed.My shop/hangar is in Alaska. Temps have been near -20 F recently and the bulbs light instantly in an unheated building. No warm up, no flicker, no noise. The difference is phenomenal!Yeah-sure, at first blush they are a bit more expensive than standard florescent bulbs, but that is a short sighted evaluation. We had a number of fixtures that had two burned out bulbs and a dead ballast. The replacement ballast alone cost nearly $35 each, plus about $10 for each florescent bulb. To get the fixture back into operation was going to cost us more than $55 and the bulbs are short lived in our Alaska winter weather. Considering that the LED light is brighter, uses a fraction of the electricity, lights instantly on these cold winter days and have a 3 year guarantee, it is a no brainer.The bulbs come with something like an instruction sheet but you might want to hire an electrician if you cant use You-tube, or know absolutely nothing about electricity. I used my husband and his tools. They are both a bit old and don’t move so well, but I found that method very convenient.)You will save yourself time if you purchase a roll of solid core, 16 gauge wire to easily rewire the fixture once the ballast has been removed. You will need a few wire nuts…orange, yellow, red, and grey.Walking into the shop now is a bit like walking into an operating room, except the shop floor is not as clean and occasionally you find grease on the tools instead of blood…..okay, occasionally my husband leaves a little blood on his tools as well.I love the new LED lights, would never go back.

Reviewer: Country must be country wide!
Rating: 4.0 out of 5 stars
Title: Still working
Review: Easy to install, nice and bright. I had an issue with one of the contacts on one bulb so I had to switch it out with another.

Reviewer: Rock_Dogg
Rating: 5.0 out of 5 stars
Title: These light tubes are so much quieter and brighter
Review: I replaced the old fluorescent T12 8 ft tubes in my garage. I have 10 light fixtures each with two bulbs. The old fluorescent light fixtures provided good light but sounded like a welder transformer. The old 60 hz hum of the light ballast was quite noisy. The fluorescent bulbs took time to warm up before getting bright. The new LED lights seem as if they are twice as bright as the fluorescent when turning on. No need to warm up. No more annoying hum. I picked this fluorescent light because it was a good balance of brightness and price. I like that it had a 270° angle on the LEDs. These lights say they are 50 Watts. There are other lights on Amazon that say 75 watts but have the same number of LED chips and look identical. Maybe the only difference is the price. As far as the LED bulb construction it is a thin tube much smaller than the T12. The backside of the LED bulb is made of aluminum with a thin plastic cover on the front. I ordered two 12 packs of this bulb. Of the 24 bulbs I received one bulb had problems. I contacted the company and received a quick response. The company refunded the cost of the bulb promptly. The ballast bypass was simple. It took approximately 10 minutes per fixture. One reason I chose JESLED was the 3-year warranty and that the company seems more established than other companies on Amazon. When choosing the right LED bulb replacement there are so many choices it can be difficult. I can tell you so far I’m very happy with my choice of this bulb replacement. I can’t speak to the reliability overtime of these bulbs yet but I can tell you the replacement wiring was simple the light is bright and the bulbs are quiet.

Reviewer: David Z
Rating: 1.0 out of 5 stars
Title: flickers badly see video
Review: I bought a set of 4. 2 flickered. I asked for replacements and was sent another set of four. Out of that set, 3 flickered. These are not worth your time. The hours I spent working to determine which were good and which were bad and then if my electric was the source of the problem (it is not) is lifetime I will not get back. Super disappointed for a product I was excited to purchase. It is worse in person than it looks in the video.On a side note, the seller had offered to refund me, even for the ones that work as an apology for sending defective items. But then they ghosted me after making the offer. They insisted that I send them a video through the amazon platform that doesnt support sending videos or urls. I suggested that they look at my review which has a video of the horrid flickering. And now that I cut the ballast out of the light, I am stuck using LED bulbs.

Reviewer: Derek D. Bergey
Rating: 5.0 out of 5 stars
Title: Could be an operating room
Review: Fantastic upgrade. Simple install. Just cut out the bypass box. The red and blue wire go to the black.And the white goes to white and black (that is not the power) and done.If you have two lights that span together, remember that circuits needs to be a loop. If not you’ll have one light bulb on and one off.There’s a great YouTube channel called Edison Lighting Supply that helped me.Make sure powers off. Super easy to install. Excellent upgrade.

Reviewer: Chris
Rating: 5.0 out of 5 stars
Title:
Review: Product was easy to install and really lit up our workshop.

Price effective as of Jun 28, 2025 06:21:23 UTC

As an Amazon Associate Dealors may receive a commission for purchases made through these links.