Customers say
Customers find the fuse holder works well and is easy to install, particularly for quick vehicle repairs. They appreciate its build quality, with one customer noting the heavy gauge wire, and consider it good value for money. The seal receives positive feedback, with one customer describing it as very tight around the fuse holder. While customers like the wire gauge, opinions about the fit are mixed.
Make It Yours – See Your Price On Amazon!
Your Sales Price $25.99 - $8.99
A quick rundown of this product’s key features:
Package Included: 6 X Mini Blade Fuse Holder and 6 X 15A Mini Blade Fuse
14 AWG thick red pigtail wire allow you to cut and splice it into any project, Wire length:30cm/12inches, Wire range:14 AWG
In-line fuse holder for mini blade fuses, Suitable for 1A,2A,3A,5A,7.5A,10A,15A,20A, ideal for car truck atv boat
Material: copper+rubber, Fuse holder dimension:38x25x13mm
Waterproof design, the rubber cap fits on tightly to protect any mini blade fuse inside.NOT easy to fall off or let water in.
Our Top Reviews
Reviewer: Samantha
Rating: 5.0 out of 5 stars
Title: Great product
Review: These fuse holders are as good as any of the “big name” ones I have used for much less money. They do everything I need them to do.
Reviewer: Aidan
Rating: 5.0 out of 5 stars
Title: These are sweet for replacing those old bulky glass tube style fuse holders with modern mini fuses.
Review: Bought this for my ’86 Honda TRX200SX project. The original fuse holder was completely busted, it was one of those bulky glass tube style fuses, at 15 amp rating. Bought this pack of two, comes with two fuse holders and two good quality 15 amp mini fuses. Wired it in place of the original fuse holder and everything works as expected. The holder is built well enough and closes tightly around the fuse to keep the elements out, the wires are firmly attached and sealed in place, a good tug would not pull these things apart. Everything is as expected for a great price, if you need a good deal for 15 amp fuses with holders for your automotive project these are the ones to get. Fuse holders have about half a foot of total wire, you cut the wire somewhere in the middle and install as needed. Perfect. Will update if any problems occur, do make sure you fully close the fuse holders once the fuse is installed to insure a good seal.
Reviewer: Patrick F
Rating: 5.0 out of 5 stars
Title: Micro fuse holder ( tiny fuse )
Review: Need fuse holders for add on wiring using the tiny chip style fuse, had to have to replace stock
Reviewer: Hogn99
Rating: 4.0 out of 5 stars
Title: Great inlines.
Review: I like these. I bought two packs to run with wire harnesses for ATVs. I like the minis so these work well. So far I have run one with the supplied 5A fuse, and one with a 10A fuse due to the load. I haven’t tested, but I doubt water will get in. They should not get submerged where I installed them, but the splashing should not affect them. Opening and closing was not a big deal, as some reviews said. My issue was how tight the fuses fit; putting the first one in was tough, to the point I bent the fuse a little. Take your time and work them in slowly. After that I was able to pull and install much easier. Will buy again.
Reviewer: Aaron D.
Rating: 5.0 out of 5 stars
Title: For the price these work great.
Review: They look good and work as described. The wire fits perfect in the correct crimp connector. (Blue)
Reviewer: Robert J.
Rating: 5.0 out of 5 stars
Title: Does its job well in my application. Well made
Review: These did the job I needed them to do. I cannot speak to the weather roof or waterproof properties of this item, because mine are mounted in my trunk, but the seal slips over the fuse nice and snug. The fuse is also held into the body of this very snug, so contact is great. Wire gauge is beefier than most, which is why I chose this one in particular. Doing well for me!
Reviewer: William F. Swanson
Rating: 5.0 out of 5 stars
Title: Well built, easy to use
Review: Used these to re-wire some switches in the stern of my 2004 Sailfish 236cc. Worked great, nice seal on the fuse too.
Reviewer: mustwatchtv
Rating: 5.0 out of 5 stars
Title: Will buy again
Review: Very happy with this product, I used it on my bilge pump for my boat. Installation was easy and the perfect gauge wire.
Price effective as of Apr 20, 2025 21:07:24 UTC
As an Amazon Associate Dealors may receive a commission for purchases made through these links.
